EPA FIFRA REGISTRATION

The USEPA has accepted Modec's Label for its Modec Decon Formulation. Approved for antimicrobial disinfectant and fungicidal uses, Modec's Decon Formulation has been assigned EPA Registration No.'s 80364-1 and 80364-2 witn California Department of Pesticide Registration 218536, 218548. When used as directed, MDF-500 exhibits effective disinfectant activity against the organisms: Staphylococcus aureus, Salmonella choleraesuis, Pseudomonas aeruginosa, and meets the requirements for hospital use.

FUNGICIDAL ACTIVITY - MDF-500 has demonstrated to be fungicidal against pathogenic fungi (Trichophyton mentagrophytes). Our testing pursuant to EPA DIS/TSS-6 established the formulation as effective in direct test against fungal spores. Thus, MDF-500 is an effective mildewstat and fungicidal against mold and mold spores.

Modec completed and submitted the required toxicology, chemical analysis and efficacy test reports required by law and submitted its formulation to the EPA review under Section 3 Registration requirements prescribed by FIFRA. Many of the laws, guidance, and policies that govern the Office of Pesticide Programs (OPP) are contained in the Federal Insecticide, Fungicide, and Rodenticide Act. Modec's Decon Formulation can be used in commercial and residential applications. Modec's Decon Formulation is produced in EPA Reg. Est. CO-65001-01.

MODEC DECON FORMULA – “MDF” is a binary (two part) system. Before use, mix equal parts of MDF PART A and MDF PART B. Apply the newly mixed solution as a spray onto hard nonporous surfaces as directed below.

DISINFECTION, DEODORIZING AND CLEANING - Remove gross filth or heavy soil prior to application of the product. Spray area until it is covered with solution. Allow product to penetrate and remain wet for ten minutes. No scrubbing is necessary. The product will not leave grit.

BACTERICIDAL ACTIVITY - When used as directed, this product exhibits effective disinfectant activity against the organisms: Staphylococcus aureus, Salmonella choleraesuis, Pseudomonas aeruginosa, and meets the requirements for hospital use.

MILDEWSTAT - To control mold and mildew on hard, non-porous surfaces, spray surface to be treated by making sure to wet completely. Let air dry.

FUNGICIDAL ACTIVITY - This product has been demonstrated to be fungicidal against Trichophyton mentagrophytes. Use as directed on hard, non-porous surfaces.

Manufacturer has completed its FDA Pre-market Notification for use of the product as a skin decontaminant pursuant to Section 510(k) of the Food and Drug Act. Clinical trials have been completed and provided to the FDA.

MDF-120 - Antiseptic Skin Decon Kit

PRODUCT DESCRIPTION: MDF-120 is the first safe, non-toxic first-aid antiseptic specifically designed as a topical decontaminant for the skin. It is non-flammable, biodegradable and does not contain alcohol-based sanitizers. This proprietary patented aqueous-based media contains emollients and moisturizers to protect the skin as well as a unique species of oxidants that enhances the physical action of hydrophilic solubilization of materials that are sparingly soluble.

USE: For topical application to the skin to prevent infection and to help prevent cross contamination. Established as safe and effective with germicidal effect during short-term use. Reduces the transmission of pathogenic microorganisms to patients and personnel.

COMPLIANCE WITH FEDERAL REGULATIONS
IAQM's Formulation is produced in EPA registered facilities to ensure compliance with 40 CFR Part 712 and all pertinent EPA and Toxic Substances Control Act ("TSCA") regulations. Contents Decon and Structural Decon is labeled in accordance with EPA requirements for use on Weapons of Mass Destruction consisting of chemical agents. Pursuant to Section 8(a) of the Toxic Substances Control Act (15 U.S.C. 2607), the EPA has been given the broad authority to require manufacturers and producers of chemical substances to maintain and report information regarding regulated chemicals.

The IAQM Decontamination process offers the unique advantage deriving from the careful crafting and melding of capabilities of resources. The result is a strong capability which offers our clients four distinct advantages:

• an overwhelming technical capability to address performance requirements;
• an established and successful record of managing and fielding complex systems for decon programs;
• a partner prepared to provide the resources and capabilities to succeed in all contract phases;
• a low risk program for the client with proven decontaminant products.

These advantages are manifested in the following ways:

• ISO 9001 certified quality control program
• Extensive Program Management including Life Cycle Maintenance
• Successful record of management of complex defense programs
• ILS Supportability
• Extensive Defense and Commercial Industry Expertise
• High Volume Production Capability to 40,000 gallons daily
• Best economic value
• Web-based product support system
• Completed or in-progress regulatory filings with the FDA and EPA
• Experienced Key Personnel with proven expertise in Program Management, Testing, Acquisition Logistics, System Engineering, Chemistry, Cost Accounting, Risk Analysis, Contracts and Quality Assurance.
  

Regulatory Matters
The elements used in the production of IAQM's Decon Formulation are listed on the Toxic Substances Control Act Inventory List and are biodegradable. The IAQM Decon Team intends to implement a System Safety Program (SSP) utilizing MIL-STD-882C as a guide. Material Safety Data sheets required by 29 CFR 1910.1200 are supplied with all products. IAQM conducts ongoing stability and sampling plan in accordance with Quality System Regulation 21 CFR Part 820.

Disaster Facts
It is important to have all the information possible about domestic preparedness, first response and chemical and biological agents. The more you know, the easier it is to be ready.

Fast Fact 1:
Chemical agents come in all states (liquid, gas, solid) - however, most are liquids. Some of the original compounds used in war were gases - simply because they were readily and commercially available.

Fast Fact 2:
Some Chemical agents have odors, others do not. For example, distilled sulfur mustard in odorless, while a less-pure sample would have a faint garlic smell. The nerve agents sarin and VX are odorless; the choking agent phosgene smells like freshly mowed hay, while hydrogen cyanide has an odor of bitter almonds.

Fast Fact 3:
Microorganisms are specifically identified by their genus and species. Many people refer to biological agents simply as Tularemia, Anthrax and the Plague. In fact, these terms diseases that the microorganisms cause.

Fast Fact 4:
The terms vesicant and blister can be used interchangeably to categorize agents such as mustard and lewisite. A vesicant is a blister-producing agent.

Fast Fact 5:
Terrorists don't need advanced chemical and biological agents to achieve their goals. As an example, several of the chemical agents originally used in World War I were widely available in general industry; examples include chlorine and phosgene. Today, these chemicals are still important industrial compounds used in the preparation of numerous products.